I don’t mean BETTER. That’s a different conversation. I mean cooler.
An old CRT display was literally a small scale particle accelerator, firing angry electron beams at light speed towards the viewers, bent by an electromagnet that alternates at an ultra high frequency, stopped by a rounded rectangle of glowing phosphors.
If a CRT goes bad it can actually make people sick.
That’s just. Conceptually a lot COOLER than a modern LED panel, which really is just a bajillion very tiny lightbulbs.
The original tv remote didn’t use batteries. It used sound. Giant clunky devices with large tactile buttons. Never runs out of batteries and still works if your kid tries to block the screen to keep you from turning it off
sounds loud and annoying
Those remotes used little spring-loaded mechanical chimes that emitted ultrasonic notes. As a kid I discovered my parents’ big Magnavox console stereo would change channels if I clinked a handful of coins.
Even the replacement and most modern remotes (with an LED at the tip that you have to point at the device) use pretty cool tech.
Usually to send data you want a data channel and a clock channel. When the clock changes say from high to low you read the next bit in the data channel. With one LED to send info you need to combine them.
For transmission that’s easy. You make the low to high change at a fixed frequency. For the high to low change if it’s a zero you make the high to low change 1/3 the way through the cycle. For a 1 you make the change 2/3 the way through the cycle.
On the receiver you you sync up a signal at the same frequency rising with the start of the transmission at a 1/2 on 1/2 off. You look at the data when the reference falls 1/2 the way through the cycle.
If a zero was sent the line had fallen at the 1/3 and it is a zero. If a one was sent the line doesn’t drop until 2/3 and it’s a one.
The trick is how do you get a signal at the same frequency and in synch. You compare the transmission frequency revived to the frequency of a voltage controlled oscillator. If it’s slower you up the voltage and increase the frequency if it’s faster you lower the voltage and lower the frequency.
You similarly use a phase detector to determine if they are in phase slightly boosting the frequency until they are in sync.
This system is called a phased lock loop (pll). All this so you don’t have to getup to change the channel. The same sort of system is used for reading data from the magnetic disk on a hard drive.
How did it generate that sound without batteries? Was it literally the audio from the clicking of the buttons? Genuine questions.
Tuning forks!!! The Zenith clicker The buttons would work strikers that would hit tuned rods. A different one doing a different function.
Ah, so more like the bell on a bicycle
Except there’s another bell that vibrates in response to trigger a switch!
It’s like auditory entanglement.
Zenith Space Command remote.
Buttons and springs would make it click loudly at a predicable frequency.
It’s why remotes are often referred to as “clickers”.
The button pressed a spring-loaded thing that struck a piece of metal, almost like a wind chime, emitting an ultrasonic note. I discovered by accident that I could make my parents’ stereo change channels by clinking coins together.
Our first TV remote was on a cable! This would have been in the early 80s I think.